Complete Campsite Uluru pack up and water question

[PeterL]

Hi
We have a (new to us) Complete Campsite Uluru soft floor, and I have two questions of anyone else that has one (or has come across similar problems with another camper trailer)
1. We set the tent up easily, but when packing the tent up one has to pull the annex back over the top of the tent (while it is still up). I haven't found an easy way to do this without having a small step ladder. How do other's do it?
2. The water tank has a hose fitting to fill, but how do you fill it if you're not near a tap? There are two jerrys, but I'm not sure how to fill the tank from a jerry. Any ideas?
Thanks
Peter

[jw2170]

HI Peter, and welcome to the forum.

For Q1....we use a vertical pole from the annex and place that in the hole in the peak of the annex, use that to push the annex back over the tent. There is also a line attached to that hole that goes over the back of the tent and a second person pulls on that. For our tent we also have small lines through the holes in the ends of the annex to pull the corners over....

Hope that makes sense....

[robcaz]

Hi Peter,

We have a ropes permanently tided to the two eyelets on the awning where the corner poles go though. When packing up camp I push the center of the awning over the top with the center pole & then we pull the two corners over to the back of the tent.

I have set up a 12volt water pump to fill the tank from jerrys http://www.campertrailers.org/robs_water_transfer.htm